• 1,000+

    installations over 10+ years

  • 24/7

    support for managed-service clients

  • Excellent

    Rated 4.9/5 by 110+ NYC corporations

  • 7 Active Teams

    Operating throughout New York

Most Brooklyn commercial buildings carry readers, cameras and cable from several past tenants. We keep what works and deliver one system the owner can run, as we do for commercial security systems across New York.

Security systems we install in Brooklyn

Security systems in Brooklyn start with access control and cameras, then add the layers the building needs.

  • Access control

    As a certified Salto dealer and Brivo dealer, we deploy cloud-managed Salto KS or Brivo for owners who are not on site, with HID Mobile Access phone credentials, Genetec where one unified platform is needed and Dorma locking hardware. Platforms are compared on our access control Brooklyn page.

  • Cameras

    NDAA-compliant Axis and Genetec cameras recorded on Exacq. Low-light and PTZ models cover docks and yards after dark, and vehicle detection at gates and docks flags arrivals. More on commercial camera systems.

  • Lobby and elevator control

    Credentials that work from the street door to the tenant floor. Elevator access control integrates with all major elevator brands, including Braxos.

  • Intrusion detection

    Sensors on roll-down gates, roof hatches and rear doors. Monitored systems alert security personnel or emergency services, with camera footage attached to each alarm.

  • Intercom

    Video intercoms with a per-tenant directory, so tenants answer couriers from a phone and release the door remotely.

  • Cabling and network

    Fiber between buildings, tested Cat6/Cat6A to every device, and a segmented network for security devices.

Brooklyn business districts and what each needs

Security system installation in Brooklyn changes with the district. The building type sets the brief before any device is chosen.

Loft office entrance in exposed brick with a card reader beside the door and a dome camera above
DistrictTypical buildingsDesign priorities
Downtown Brooklyn, MetroTech and Fulton StreetOffice and education towers; Fulton Mall retailLobby entry tied to tenant floors; stockroom control
Brooklyn Navy YardManufacturing and studio tenants on a managed campusTenant systems inside the Brooklyn Navy Yard Development Corporation's campus rules
Industry City, Sunset Park and Brooklyn Army TerminalLarge industrial complexes inside Industrial Business ZonesShared corridors, docks and freight elevators
Williamsburg and GreenpointNew waterfront mixed-use with ground-floor retailRetail separated from upper floors; garage coverage
Bushwick and East WilliamsburgIndustrial lofts turned studios, offices and venuesReplacing piecemeal tenant systems; heavy doors
DUMBO and Brooklyn HeightsHistoric warehouses and commercial buildingsConcealed routing; LPC review where required

In the Brooklyn Tech Triangle (DUMBO, Downtown Brooklyn and the Navy Yard), tenants expect phone credentials from day one.

See our completed work across NYC

Brooklyn's venues need multi-system work with no gaps between trades. Pacha NYC shows that model at scale.

Pacha NYC sign at night
Hospitality and nightlife01 / 01

Technology systems for Pacha NYC

Problem: Pacha / Five Development needed every system across two venues, Brooklyn Hall and Pacha, on a shared trade timeline.

What we did: Structured cabling and fiber, integrated access control, over 200 AI-powered cameras and bespoke real-time occupancy software, with 25+ technicians working at once.

Result: Live occupancy data for both venues and ongoing support from the same team. Read the Pacha NYC project.

★★★★★
“The team was punctual, professional, and explained everything clearly. System has been working flawlessly for 6 months now. Really appreciate how they worked around our business hours to minimize disruption.”
James Hughes, small business

Running a Brooklyn building on a patchwork system?

Request a site assessment, on site or virtual. We'll tell you what to keep.

Rated 4.9/5 5 stars by 110+ New York City businesses

Building conditions that shape a Brooklyn design

Brooklyn's building stock sets hard constraints. We settle these at survey, before pricing is final.

  • Masonry and heavy timber

    Thick brick slows every cable path. Wireless battery locks avoid coring doors where cabling would cost more than the hardware.

  • Abandoned tenant wiring

    We trace and remove decades of dead cable so the new system starts clean.

  • Large floor plates

    A copper Ethernet run tops out at 100 meters. Intermediate closets or fiber keep distant readers and cameras online.

  • Flood zones

    Parts of Red Hook, Gowanus, Greenpoint and the Navy Yard sit in FEMA flood zones. Where NYC Building Code Appendix G applies, controllers and power supplies go at or above the design flood elevation.

  • New egress paths

    Conversions add exits. Each electrified lock is set fail-safe or fail-secure to code, maglocks get a sensor and manual release, and fire alarm release is coordinated with that vendor.

We resolve these through security design and consulting before anything is ordered.

One owner, many tenants, one accountable partner

In Brooklyn, security builds up one lease at a time. We bring it onto one platform, with as-built documentation for the whole building.

  • One system

    The owner controls shared doors, docks and cameras. Tenant suites keep their own permissions inside the same platform.

  • One contact

    Repairs and lifecycle support for every reader, lock and cable, whoever installed it. We service all major brands.

How a Brooklyn project runs

A Brooklyn project usually begins with an audit of what is already installed.

  1. 01

    Audit

    Every door, dock and closet, and what can be reused.

  2. 02

    Design

    Drawings, pathways, platform and tenant permissions.

  3. 03

    Installation

    Scheduled around building access. Larger buildings are phased by floor or tenant.

  4. 04

    Cutover and testing

    Every device verified; as-builts handed over.

  5. 05

    Support

    Managed service and maintenance includes 24/7 support for existing clients, with a 4-hour response on critical failures.

FAQs

Brooklyn security systems FAQs

Short answers on multi-tenant buildings, alarms, cost, elevators and historic districts in Brooklyn.

Do you offer security system installation in Brooklyn for multi-tenant industrial buildings?

Yes, we offer security system installation in Brooklyn for multi-tenant industrial buildings, including converted warehouses. The owner controls shared doors and docks; each tenant manages its own suite on the same platform.

Do you install commercial alarm systems in Brooklyn?

Yes, we install commercial alarm and intrusion detection systems in Brooklyn, linked to cameras and access control. Fire alarm stays with a licensed fire alarm vendor.

How much do business security systems in Brooklyn cost?

Business security systems in Brooklyn are priced by door count, distances and existing wiring. Masonry and how much legacy hardware can be reused move the budget most, so we price after a site assessment.

Do you provide elevator access control and lobby security for Brooklyn office and mixed-use buildings?

Yes, we provide elevator access control and lobby security for Brooklyn office and mixed-use buildings. A tenant's credential opens the lobby and calls only the floors it is allowed to reach, with visitors logged on the same platform.

Can you install security systems in Brooklyn historic districts like DUMBO and Brooklyn Heights?

Yes, we install security systems in Brooklyn historic districts, including DUMBO and Brooklyn Heights. Where Landmarks Preservation Commission approval applies, concealed routes and wireless locks limit visible change.

Request a site assessment for your Brooklyn building

Show us the building. We'll design one system and support it after handover.

Rated 4.9/5 5 stars by 110+ New York City businesses

Call Site assessment